Паспорт и руководство по эксплуатации 4224-001-12704605-2001 пс

Паспорт и руководство по эксплуатации

4224-001-12704605-2001 ПС

200­__ г.

Сведения об авторских правах.

1. 
   Автор изобретения и разработчик индикатора:
   Кравченко Юрий Павлович,
   Российская Федерация, г. Уфа.
   
2. 
   Прибор обладает патентной чистотой на территории РФ и защищен следующими документами:
   

ПАСПОРТ

1. Назначение

2. Принцип действия

3. Технические характеристики

4. Комплектность ( Рис. 1 )

6. Хранение

Прибор ИГА-1 №___________ изготовлен и принят в соответствии с действующей технической документацией, ТУ 4224-001-12704605-2001 и признан годным для эксплуатации.

Зам. директора ___________________ / Иващенко В.Н. /

РУКОВОДСТВО ПО ЭКСПЛУАТАЦИИ

1. Подготовка к работе

Перед началом работы необходимо установить органы управления в следующие положения:

секунды и отпустить кнопку обнуления. При этом стрелка индикатора должна в течение не мене 5 секунд оставаться на нулевой отметке с точностью одно маленькое деление.

секунды и отпустить кнопку обнуления. При этом стрелка индикатора должна в течение не мене 5 секунд оставаться на нулевой отметке с точностью одно маленькое деление. Нажать на 3-4 секунды и отпустить кнопку обнуления. Плавно поднести ладонь к антенне прибора (не касаясь самой антенны) на расстояние 3-10 см. При этом стрелка индикатора скачкообразно должна отклониться. В случае, если стрелка индикатора отклоняется слабо, необходимо переключатель ФИЛЬТР установить в положения 1или 2 и повторить операции пп. 1.9, 1.10.

2. 
   Методика определения границы пустот, трассы водяной жилы (Геопатогенные зоны на земельных участках).
   

3. 
   Разведка пустот, определение трассы водяной жилы
   

6. Регламентные работы

Периодически, через 25 часов эксплуатации протирать салфеткой, смоченной спиртом, антенну и изолятор измерительного датчика. При работе в запыленных условиях чистку антенны и изолятора проводить каждый раз после работы, после чего просушить измерительный датчик при температуре плюс 20С в течение 30 мин.

8. Адрес изготовителя.

Data on copyrights.

1. 
   The author of invention and developer of indicator:
   Kravchenko Yurii Pavlovich,
   Russian Federation, Ufa.
   
2. 
   Device possesses patent cleanliness on territory of R.F. and protected by following documents:
   

Passport

1. Appointment

2. Action principle

3. Technical characteristics

4. Completeness ( pic. 1 )

6. Storage

Device IGA-1 №___________ is made and accepted according to operating engineering specifications, ТУ 4224-001-12704605-2001 and recognized by serviceable.

The deputy director ___________________ / Ivashenko V.N. /

The operation manual

4. Prepare for working

Before the work beginning it is necessary to establish controls in following positions:

To Take the device for the handle and to focus a plane of aerials downwards in parallel an earth surface. To press the zeroing button. Keeping the button in the pressed condition and smoothly rotating the handle ГРУБО clockwise to achieve occurrence of insignificant fluctuations of an arrow of the indicator about zero position. Then smoothly to rotate the handle ГРУБО counter-clockwise to an establishment of steady indications of the indicator (elimination of fluctuations). To release the zeroing button. To press on 3-4

seconds and to release the zeroing button again. Thus the arrow of the indicator should remain within not less than 5 seconds on a zero mark with accuracy one small division.

To Take the device for the handle and to focus a plane of aerials downwards in parallel an earth surface. To press the zeroing button. Keeping the button in the pressed condition and smoothly rotating the handle ГРУБО clockwise to achieve occurrence of insignificant fluctuations of an arrow of the indicator about zero position. Then smoothly to rotate the handle ГРУБО counter-clockwise to an establishment of steady indications of the indicator (elimination of fluctuations). To release the zeroing button. To press on 3-4

seconds and to release the zeroing button again. Thus the arrow of the indicator should remain within not less than 5 seconds on a zero mark with accuracy one small division. To press for 3-4 seconds and to release the zeroing button. To bring a palm to the device aerial smoothly (without concerning the aerial) on distance of 3-10 sm. Thus the arrow of the indicator in steps should deviate. In a case if the arrow of the indicator deviates poorly, it is need to establish the switch ФИЛЬТР in position 1or 2 and repeat points. 1.9, 1.10.

5. 
   The Technique of definition of border of emptiness, lines of a water vein (Geopathogenic zones on the ground areas).
   

1. 1. 
      The Device reacts and to communications passing in investigated area which bring errors in measurement process, are a hindrance at detection of emptiness and water veins. (pic. 2):
      
      1. 
         on pipeline edges (an axial signal) points 4,5;
         
      2. 
         op trench edges, points 3,6.( Provided that the ground density in trench differs from density of a ground out of a trench);
         
      3. 
         on secondary signals points 1,2,7,8;
         
   2. 
      secondary signals from polyethylene pipelines are stronger, than an axial signal.
      
   3. 
      from metal pipelines the axial signal is stronger than the secondary.
      
   4. 
      Lieing down depth of the pipeline is equal to distance between a line of edge of a pipe (points 5 or 4) and the line of a secondary signal located on the same party (8 or1).
      
   5. 
      Search works is better to make in dry or frosty weather, and also at in regular intervals humidified ground. At moisture hit on the device aerial, it is necessary for drying.
      
   6. 
      The device Aerial should be on distance not less than 1 meter from the earth.
      
   7. 
      Seasonal passage of electromagnetic radiation of the Earth reaches a maximum in December - January, a minimum in June-July. Accordingly optimum months for works with the device are December-January, least - June-July. Before the beginning of search works by means of the device it is necessary to make a zero exhibition in a search place according to points 1.9 and 1.10. After a zero exhibition, smoothly moving the measuring gauge along an earth surface, and periodically nulling it, to note a place where the indicator in steps deviates zero position. Then to recede from noted point on 1-2 meters, and moving on a circle from noted point, to find the following point where the indicator in steps deviates zero position. Moving along the line formed by found points, to make a mark of a contour of emptiness or a line of a water vein.
      
2. 
   Investigation of emptiness, definition of a line of a water vein
   

6. Procedural works

Periodically, in 25 hours of operation to wipe a napkin moistened with spirit, the aerial and an insulator of the measuring gauge. At work in dusty conditions aerial and insulator cleaning to spend each time after work then to dry the measuring gauge at temperature + 20С during 30 min.

e-mail   astra.47@mail.ru ,  astra-47@yandex.ru

www.iga1.ru Geophysical Anomaly Detectors

2

31

1

32

4

29

3

30

6

27

5

28

8

25

12

21

11

22

14

19

13

20